6: Configuration via Serial Mode or Telnet PortWiPort Embedded Wireless Device Server User Guide 47Figure 5-4. Setup Menu OptionsChange Setup:0 Server1 Channel 12 Channel 23 E-mail4 WLAN5 Expert6 Security7 Defaults8 Exit without save9 Save and exit Your choice ?5. Select an option on the menu by entering the number of the option in the Yourchoice ? field and pressing Enter.View the current configuration by pressing Enter from the Change Setup menu.To enter a value for a parameter, type the value and press Enter. To confirm acurrent value, press Enter (without inputted parameters).6. When finished, save the new configurations (9 Save and exit). The unit reboots.Server Configuration (Option 0)The unit’s basic server (i.e. network) values display upon selecting Server (option 0from the Change Setup menu). The following sections describe the configurableparameters within the Server configuration menu.Network ModeSelect the network mode for the WiPort. Options available are Wired Only, WirelessOnly, and Bridging. For more information on Bridging, see 8: Wireless Bridging onpage 85.Network Mode <0=Wired Only 1=Wireless Only 2=Bridging>:Set the IP AddressIf DHCP is not used to assign IP addresses, enter it manually. The IP address mustbe set to a unique value in the network. Enter each octet and press Enter betweeneach section inputted. The current value is displayed in parentheses.IP Address : ( 0) ( 0) ( 0) ( 0) _Set the Gateway IP AddressThe gateway address, or router, allows communication to other LAN segments. Thegateway address should be the IP address of the router connected to the same LANsegment as the unit. The gateway address must be within the local network.The default is N (No), indicating the gateway address has not been set. To set thegateway address, type Y. At the prompt, enter the gateway address.Set Gateway IP Address (N) ? YGateway IP addr ( 0) ( 0) ( 0) ( 0)_