Lantronix WiPort User Manual

Also see for WiPort: Integration guide User guide Quick start guide

Contents

Lantronix WiPort User Manual Manual pdf 49 page image

6: Configuration via Serial Mode or Telnet PortWiPort Embedded Wireless Device Server User Guide 49For example, if the MAC address is 00-20-4A-12-34-56, then the defaultDHCP name is C123456. Custom DHCP Name: Create your own DHCP name. If using an IP addressof 0.0.0.0, then the last option in Server configuration is Change DHCPdevice name. This option allows you to change the DHCP name to analphanumeric name (LTX in the example).Change DHCP device name (not set) ? (N) YEnter new DHCP device name : LTX Numeric DHCP Name: You can change the DHCP name by specifying thelast octet of the IP address. When you use this method, the DHCP name isLTXYY where YY is what you chose for the last octet of the IP address. If theIP address you specify is 0.0.0.12, then the DHCP name is LTX12. Thismethod only works with 2-digit numbers (0-99). The third octet of the IP address sets the BootP/DHCP/AutoIP options. Todisable an option, set the appropriate bit:Table 5-2. BootP/DHCP/AutoIP optionsOptions BitAutoIP 0DHCP 1BootP 2 For example, if the third octet is 0.0.5.0, the AutoIP and BootP options aredisabled; only DHCP is enabled. (The value 5 results from adding the binaryequivalents of 0 and 2.) This is the most common setting when using DHCP. Enable DHCP FQDN: You can choose to enable or disableDHCPFQDNbyspecifying Y orN."Channel 1 (Option 1) and Channel 2 (Option 2) ConfigurationSelect option 1 Channel 1 or 2 Channel 2 from the Change Setup menu to definehow the serial port responds to network and serial communications. The followingsections describe the configurable parameters within the Channel configurationmenu.Table 5-3. Serial and Telnet Port ParametersBaudrate (9600) ?I/F Mode (4C) ?Flow (00) ?Port No (10001) ?ConnectMode (C0) ?Send '+++' in Modem Mode (Y) ?Show IP addr after 'RING' (Y) ?Auto increment source port (N) ?Remote IP Address : (000) .(000) .(000) .(000)Remote Port (0) ?DisConnMode (00) ?FlushMode (00) ?DisConnTime (00:00) ?:SendChar 1 (00) ?