Lantronix WiPort User Manual

Also see for WiPort: Integration guide User guide Quick start guide

Contents

Lantronix WiPort User Manual Manual pdf 60 page image

6: Configuration via Serial Mode or Telnet PortWiPort Embedded Wireless Device Server User Guide 60(1) The WiPort sends the "Terminal Type" upon an outgoing connection.(2) A password is required for a connection to the serial port from the network.(3) The TCP connection closes even if the remote site does not acknowledge the disconnection.(4) When there is a network connection to or from the serial port, the state LED turns off instead of blinking.(5) When Ctrl-D or Hex 04 is detected, the connection is dropped. Both Telnet Com Port Cntrl andDisconnect with EOT must be enabled for Disconnect with EOT to function properly. Ctrl+D is onlydetected going from the serial port to the network.(6) When Modem Control In transitions from a high state to a low state, the network connection to or from theserial port drops.Flush ModeThe FlushMode (buffer flushing) parameter controls line handling and network bufferswith connection startup and disconnect.FlushMode ( 0) ? _Select between two different packing algorithms (the current configuration isdisplayed within the parentheses). Available Flush Mode options are:Table 5-13. Flush Mode OptionsFunction 7 6 5 4 3 2 1 0Input Buffer (Serial to Network)Clear with a connection that is initiated from thedevice to the network 1Clear with a connection initiated from the networkto the device 1Clear when the network connection to or from thedevice is disconnected 1Output Buffer (Network to Serial)Clear with a connection that is initiated from thedevice to the network 1Clear with a connection initiated from the networkto the device 1Clear when the network connection to or from thedevice is disconnected 1Alternate Packing Algorithm (Pack Control)Enable 1Pack ControlThe packing algorithm defines how and when packets are sent to the network. Thestandard algorithm is optimized for applications in which the unit is used in a localenvironment. The alternate packing algorithm minimizes the packet count on thenetwork and is especially useful in applications in a routed Wide Area Network(WAN). Adjusting parameters in this mode can economize the network data stream.Pack control settings are enabled in Flush Mode. Set this value to 00 if specificfunctions are not needed.