XPress DR+ User Guide 163: Installation and HardwareWhat's in the Box?Verify and inspect the contents of the package using the enclosed packing slip orthe list below. If any item is missing or damaged, contact your place of purchaseimmediately. XPress DR+ XPress DR+ resource CD Quick Start Guide P/N: 500-103 RJ45-DB9F serial cable Accessory DIN-rail wall mount bracket 3 terminal screw connector for power input 5 terminal screw connector for serial portWhat must the user provide? 9-30 VDC or 9-24 VAC power source CAT 5 Ethernet cablePhysically Connecting the UnitNote: To comply with the FM approval of the XPress DR+, it must be installed in a tool-secured enclosure and wiring must be installed in accordance with Division 2 wiringpractices as specified by the NEC.This section describes the procedures for getting your unit up and running. For a shortversion, see the Quick Start Guide. Detailed descriptions of the hardware components ofthe XPress DR+ follow this simple installation procedure.The following diagram shows the basic connectivity of an XPress DR+ to the network anda serial device. The Lantronix supplied P/N: 500-103 serial cable can be used on theRJ45 RS232 serial ports to connect the XPress DR+ to a PC or to a serial device thathas a DB9M RS232 DTE interface. If the device being connected uses a different serialinterface, please refer to page 20 for the serial interface pinout or to B: Lantronix Cablesand Adapters for a list of serial cables or adapters.
