XPress DR+ User Guide 477: Setup Mode: Server ConfigurationThis chapter explains how to configure the network settings.Note: Current values display in parentheses.Server Configuration (Option 0)The unit’s basic network parameters display when you select Server configuration(option 0). The IP Address, Set Gateway IP Address, and Netmask fields display thecurrent values.Figure 7-1. Server SettingsIP Address : (000) .(000) .(000) .(000)Set Gateway IP Address (N)Netmask: Number of Bits for Host Part (0=default) (0)Change telnet config password (N)IP AddressIf DHCP is not used to assign IP addresses, enter the IP address manually. The IPaddress must be set to a unique value in the network. Enter each octet and press Enterbetween each section. The current value displays in parentheses.IP Address : ( 0) ( 0) ( 0) ( 0) _If DHCP is used, the third octet of the IP address sets the BootP/DHCP/AutoIP options.The following table shows the bits you can manually configure to force the XPress DR+to disable AutoIP, DHCP, or BootP. To disable an option, set the appropriate bit.Table 7-1. BootP/DHCP/AutoIP optionsOptions Bit ValueAutoIP 0 1DHCP 1 2BootP 2 4For example, if the third octet is 0.0.5.0, the AutoIP and BootP options are disabled; onlyDHCP is enabled. (The value 5 results from adding the binary equivalents of 0 and 2.)This is the most common setting when using DHCP.
