Menu LanguageThis affects the language of the TV/DVD’s setup menus andon-screen display terms.This does not alter the language ofTV programming or discs.● Before you begin, press SELECT to put the TV/DVDin TV mode.1 Press SETUP.2 Press ▲ or ▼ to select LANGUAGE.3 Press ENTER to select ENGLISH, ESPAÑOL orFRANÇAIS. The selected language will flash insidethe [ ].This will be the language of the TV/DVD setupmenus.4 Press SETUP to exit the menu.18 Menu Language, Auto Channel Programming• If you select Spanish or Frenchbut need English menus, pressSETUP. Press ▲ or ▼ to selectIDIOMA or LANGAGE. PressENTER to select ENGLISH.Then,press SETUP.• The TV/DVD cannot changechannels at the Cable Box orSatellite Receiver. Set the TV/DVDto channel 3, 4 or AUX. Changechannels at the CableBox/Satellite Receiver. Details areon page 9.• Channel settings will be savedeven if the power fails.• You cannot set up TV channels ifthe unit is in DVD mode.2-31,4Helpful HintsAuto Channel ProgrammingTo auto program only the channels which are available inyour area, follow the steps below.● Before you begin, press SELECT to put the TV/DVDin TV mode.1 Press SETUP.2 Press ▲ or ▼ to select CHANNEL SET UP.Then, press ENTER.3 Press ▲ or ▼ to select AUTO CHPROGRAMMING. Press ENTER. The TV/DVDmemorizes available channels.When scanning iscomplete, the TV/DVD will go to the lowest availablechannel automatically.To stop channel scanning before it is finished, pressSETUP on the remote.2-31— TV SETUP —CHANNEL SET UPV-CHIP SET UPLANGUAGE [ENGLISH]CAPTION [OFF]B– CHANNEL SET UP –ADD / DELETE CH (CATV)AUTO CH PROGRAMMINGB— TV SETUP —CHANNEL SET UPV-CHIP SET UPLANGUAGE [ENGLISH]CAPTION [OFF]T9103_8103UD_EN_0411 4/11/05 10:43 AM Page 18