Makita DLS713 Instruction Manual

Also see for DLS713: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

5ENC007-10IMPORTANT SAFETYINSTRUCTIONSFOR BATTERY CARTRIDGE1. Before using battery cartridge, read all instructionsand cautionary markings on (1) battery charger, (2)battery, and (3) product using battery.2. Do not disassemble battery cartridge.3. If operating time has become excessively shorter,stop operating immediately. It may result in a risk ofoverheating, possible burns and even an explosion.4. If electrolyte gets into your eyes, rinse them outwith clear water and seek medical attention rightaway. It may result in loss of your eyesight.5. Do not short the battery cartridge:(1) Do not touch the terminals with anyconductive material.(2) Avoid storing battery cartridge in acontainer with other metal objects such asnails, coins, etc.(3) Do not expose battery cartridge to water or rain.A battery short can cause a large current flow,overheating, possible burns and even a breakdown.6. Do not store the tool and battery cartridge inlocations where the temperature may reach orexceed 50 ﾟ C (122 ﾟ F).7. Do not incinerate the battery cartridge even ifit is severely damaged or is completely wornout. The battery cartridge can explode in a fire.8. Be careful not to drop or strike battery.9. Do not use a damaged battery.10. Follow your local regulations relating todisposal of battery.SAVE THESE INSTRUCTIONS.CAUTION: Only use genuine Makita batteries.Use of non-genuine Makita batteries, or batteries thathave been altered, may result in the battery burstingcausing fires, personal injury and damage. It will alsovoid the Makita warranty for the Makita tool and charger.Tips for maintaining maximum battery life1. Charge the battery cartridge before completelydischarged.Always stop tool operation and charge the batterycartridge when you notice less tool power.2. Never recharge a fully charged battery cartridge.Overcharging shortens the battery service life.3. Charge the battery cartridge with roomtemperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F). Let ahot battery cartridge cool down before charging it.4. Charge the battery cartridge if you do not useit for a long period (more than six months).INSTALLATIONBench mountingWhen the tool is shipped, the handle is locked in thelowered position by the stopper pin. Release the stopperpin by simultaneously applying a slight downwardpressure on the handle and pulling the stopper pin.1011300WARNING:• Ensure that the tool will not move on thesupporting surface. Movement of the miter sawon the supporting surface while cutting may resultin loss of control and serious personal injury.This tool should be bolted with two bolts to a level andstable surface using the bolt holes provided in the tool'sbase. This will help prevent tipping and possible injury.1011236Turn the adjusting bolt clockwise or counterclockwise sothat it comes into a contact with the floor surface to keepthe tool stable.10112371. Adjusting bolt1. Bolt1. Stopper pin