Makita DLS713 Instruction Manual

Also see for DLS713: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

18Adjusting the cutting angleThis tool is carefully adjusted and aligned at the factory,but rough handling may have affected the alignment. Ifyour tool is not aligned properly, perform the following:1. Miter anglePush the carriage toward the guide fence andtighten two clamp screws to secure the carriage.Loosen the grip which secures the turn base. Turn theturn base so that the pointer points to 0° on the miterscale. Then turn the turn base slightly clockwise andcounterclockwise to seat the turn base in the 0° miternotch. (Leave as it is if the pointer does not point to 0°.)1 2012585Loosen the hex socket bolt securing the guide fenceusing the hex wrench.Lower the handle fully and lock it in the loweredposition by pushing in the stopper pin. Square theside of the blade with the face of the guide fenceusing a triangular rule, try-square, etc. Thensecurely tighten the hex socket bolt on the guidefence in order starting from the right side.100220912 3003942Make sure that the pointer points to 0° on the miterscale. If the pointer does not point to 0°, loosen thescrew which secures the pointer and adjust thepointer so that it will point to 0°.2. Bevel angle(1) 0° bevel anglePush the carriage toward the guide fence andtighten two clamp screws to secure thecarriage. Lower the handle fully and lock it inthe lowered position by pushing in the stopperpin.21543012589Loosen the lever at the rear of the tool.Turn the 0° bevel angle adjusting bolt (lowerbolt) on the right side of the arm two or threerevolutions counterclockwise to tilt the bladeto the right.123001819Carefully square the side of the blade with thetop surface of the turn base using thetriangular rule, try-square, etc. by turning the0° bevel angle adjusting bolt clockwise. Thentighten the lever securely.1 2 3011306Make sure that the pointer on the arm point to0° on the bevel scale on the arm holder. If itdoes not point to 0°, loosen the screw whichsecures the pointer and adjust the pointer sothat it will point to 0°.1. Bevel scale2. Pointer3. Screw1. Triangular rule2. Saw blade3. Top surface ofturn table1. Lever2. Arm holder3. 0 ﾟ degreebevel angleadjusting bolt4. Arm5. Release button1. Screw2. Miter scale3. Pointer1. Triangular rule1. Guide fence2. Hex socket bolt

/ 20

Related manuals for Makita DLS713