Makita MLT100N Instruction Manual

Also see for MLT100N: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

9 ENGLISHENGLISH (Original instructions)SPECIFICATIONSModel: MLT100NArbor hole(Country specific)30 mm / 25.4 mmBlade diameter 260 mmMax. cutting capacities bevel 0° 93 mmbevel 45° 64 mmNo load speed 4,300 min -1Table size (L x W)with sub tables (R) and (back)835 mm x 1,305 mm (tables extended)685 mm x 955 mm (tables stored)Dimensions (L x W x H)with sub tables (R) and (back)726 mm x 984 mm x 473mm (tables stored)Net weight 34.8 - 35.1 kgSafety class /II• Due to our continuing program of research and development, the specifications herein are subject to changewithout notice.• Specifications may differ from country to country.• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according toEPTA-Procedure 01/2014, are shown in the table.SymbolsThe followings show the symbols used for the equipment.Be sure that you understand their meaning before use.Read instruction manual.DOUBLE INSULATIONWear safety glasses.Do not place hand or fingers close to theblade.X~Xmm ( мм) Make proper clearance between the sawblade and riving knife.Only for EU countriesDo not dispose of electric equipmenttogether with household waste material! Inobservance of the European Directive, onWaste Electric and Electronic Equipmentand its implementation in accordance withnational law, electric equipment that havereached the end of their life must be col-lected separately and returned to an envi-ronmentally compatible recycling facility.Intended useThe tool is intended for cutting in wood.Straight cutting, bevel cutting, and miter cutting areavailable with this tool. This tool is not designed for non-through cutting.Power supplyThe tool should be connected only to a power supply ofthe same voltage as indicated on the nameplate, andcan only be operated on single-phase AC supply. Theyare double-insulated and can, therefore, also be usedfrom sockets without earth wire.NoiseThe typical A-weighted noise level determined accord-ing to EN62841-3-1:Sound pressure level (LpA) : 89 dB(A)Sound power level (LWA) : 100 dB (A)Uncertainty (K) : 3 dB(A)NOTE: The declared noise emission value(s) has beenmeasured in accordance with a standard test methodand may be used for comparing one tool with another.NOTE: The declared noise emission value(s) mayalso be used in a preliminary assessment of exposure.WARNING: Wear ear protection.WARNING: The noise emission during actualuse of the power tool can differ from the declaredvalue(s) depending on the ways in which thetool is used especially what kind of workpiece isprocessed.WARNING: Be sure to identify safety mea-sures to protect the operator that are based on anestimation of exposure in the actual conditions ofuse (taking account of all parts of the operatingcycle such as the times when the tool is switchedoff and when it is running idle in addition to thetrigger time).