Malibu Boats Boat User Manual

Contents

Malibu Boats Boat User Manual Manual pdf 71 page image

2-5Oil PressureThe oil pressure gauge is located at the lower center of the bottom panel of the dashdisplay. The oil pressure gauge indicates the oil pressure in the engine while the engine isrunning and is measured in pounds per square inch (psi). Oil pressure may vary withengine speed, outside temperatures, oil viscosity and other environmental factors. If theoil pressure reading is below the normal range, you should stop your engine and checkyour oil immediately.Average pressure ranges from 6 psi at 1000 RPM and 40 – 50 psi at cruising speeds. Oilpressure may be slightly higher on 5.7L engines at cruising speeds. If you are experiencinglow oil pressure, stop your engine and check your oil before operating again.Do not continue to run engine if pressure is low. If you do theengine can become so hot that the surrounding componentscould catch fire.Damage caused from neglected oil problems can be costly.Such damage is not covered by your warranty.Malibu Graphical In-Dash DisplayNote: For boats using the Viper II instrument system, refer to the Viper II owner’s manualin the information packet shipped with your boat.The following boats will include the Malibu Graphical In-Dash Display as a standardfeature:• Response• Response LX• Response TXi• VTX20This display can be found in the center of your dash console behind the steering wheel.Information is displayed in digital format for easy to read information, navigable usingthe Function up ↑ arrow, or Function down ↓ arrow followed by pressing the Enter (E)button in the center right of the display panel. The Graphical Display includes thesefeatures: Malibu Cruise, Ballast Monitoring System (BMS) “Available in wakeboardmodels only,” Air/Sea Temp, Depth meter, Power Wedge and service.Figure 2-7. In-Dash Display!WARNING