NAD VISO FIVE Owner's Manual

Also see for VISO FIVE: Catalog Brochure Datasheet Owner's manual Service manual

NAD VISO FIVE Owner's Manual Manual pdf 13 page image

MUTING THE SOUNDUse the HTR 7’s “MUTE” key to silence all channels completely (“Mute” isdisplayed in the lower line of the VFD). Muting is always available regardlessof the source or listening mode selections.NOTEAdjusting the master-volume via the HTR 7 or the front-panel knobautomatically releases the mute function.ADJUSTING CHANNEL LEVELS “ON THE FLY”You can make changes to the relative levels of center, surround andsubwoofer outputs without having to go into the “Channel Levels” menu.This is very convenient in circumstances like increasing (or tone down)a film’s dialog level by rising (lowering) the center channel or reducingexcessive deep bass (or enhance deep bass) by lowering (rising) thesubwoofer level.Use the HTR 7’s [SURR], [CENT] and [SUB] keys for direct-access leveladjustment of these channels over a range of ±12dB.The [SURR] button will adjust first Surround Left (SL) channel level. To adjustSurround Right channel level, press and release [SURR] button, the VFD willshow “SL” and the current Surround Left channel level. Wait for the displayto “SR” and the current surround right channel level. You can now to setyour preferred Surround Right channel level by pressing [SURR] key.NOTEThe lower line of the VFD will display the channel being adjusted and thecorresponding level setting.ADJUSTING THE TONE CONTROLSThe VISO FIVE bass and treble controls are adjusted using the front panel’s[TONE] button in conjunction with the VOLUME knob. The corresponding[TONE] and [VOL ] keys of HTR 7 can also perform the same functions.Referring to the lower line of the VFD, toggle [TONE] button to select “Bass”,“Treble”, “Tone Active” or “Tone Defeat”. While at either Bass or Treble mode,rotate VOLUME knob clockwise or counterclockwise to adjust the Bass or Treblelevel within the range ±12dB.Bass and treble settings affect only the front left/right channels, and areactive in all SURROUND MODES.Select “Tone Defeat” to bypass the Tone Controls effectively defeatingthe effect of the tone control circuits. If “Tone Active” is selected, the ToneControl circuits are active.FACTORY DEFAULT SETTINGSSometimes power spikes and drop-outs may from time to time cause someinadvertent functionality. The procedure below will set the VISO FIVE tofactory default settings1 Place the VISO FIVE into AM mode.2 Press quickly the three front panel buttons: [PLAY/PAUSE], [STOP] then[DISPLAY], holding the “DISPLAY” button for more than 7 seconds. TheVISO FIVE will switch itself off, then back ON to DVD mode.Please note that setting the VISO FIVE to factory default will delete all AM,FM and DAB presets. It will also reset all your timer settings.SETUPSETTING UP THE VISO FIVE13ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ