NAD VISO FIVE Owner's Manual

Also see for VISO FIVE: Catalog Brochure Datasheet Owner's manual Service manual

NAD VISO FIVE Owner's Manual Manual pdf 32 page image

EXECUTING MACROSTo execute a macro, press and release [MACRO]; its key illumination lightsfor 5 seconds. While it remains lit, press an HTR 7 key to which a macro haspreviously been stored.The corresponding macro will run; as each step executes, its “parent” DeviceSelector’s key flashes lights briefly; when execution is finished, the [MACRO]key illumination goes out. Pressing any other HTR 7 key while a macro isexecuting will abort the macro. Remember that you must hold the HTR 7 sothat its infrared emitter can activate the target components.NOTEWhen a macro executes, a 1 second delay is automatically insertedbetween its commands. If you need more than a 1 second delay betweenparticular commands—for example, to permit a component to power upcompletely—you can record “empty” steps into the macro by changingDevice Selector “pages” without entering actual command functions.BUTTON ILLUMINATION TIMEOUTThe HTR 7’s key-illumination can be set to remain lit for 0-9 seconds. Thedefault value is 2 seconds. To set the illumination timeout, simultaneouslypress-and-hold for 3 seconds both the HTR 7’s [DISP] and the [0-9] key, withthe digit corresponding to the desired timeout duration; the Learn LED willflash twice to confirm the new setting. When set to zero, the illuminationwill not turn on at all.NOTEKey illumination is the biggest drain on the HTR 7’s batteries. A shortkey-illumination timeout will extend battery life appreciably; turning itoff altogether (set it to 0 seconds) will lengthen it still further.FACTORY RESETThe HTR 7 can be reset to its factory state, deleting all learned commands,copied and punched-through keys, macros, and other setup information,reverting all keys to their pre-programmed library commands.To perform a factory reset simultaneously press-and-hold for 10 secondsthe HTR 7’s [ON] and [RTN] keys; the Learn LED will start to flash green.Release [ON] and [RTN] before the second flash is complete; the Learn LEDwill turn red, indicating the remote has been reset.NOTEYou must release [ON] and [RTN] before the second flash goes out, otherwisethe unit will not reset; should this occur, repeat the full procedure.DELETE MODEThe HTR 7 can store learned, copied, and “default library” commands on anysingle key (The default library commands are the pre-programmed NADcodes, such as the native VISO FIVE commands on the [AMP] “page.”).You can delete commands by layers back “down” to the default librarycommand on any key, removing learned commands, punched-throughfunctions, and copied keys.NOTEThe default library commands cannot be deleted, so you need not worrythat using Delete Mode might cause irreparable changes.To enter Delete Mode, simultaneously press-and-hold for 3 seconds boththe desired key’s Device Selector key and the [RTN] key, until the Learn LEDturns green. Press the function key whose command you wish to delete;the Learn LED flashes; the number of times indicates which type of functionhas become active - see the table below. Press the active Device Selectorkey again to exit Delete Mode.NOTEYou may delete multiple function-key commands on the same DeviceSelector “page,” but to delete from more than one Device Selector pageyou must exit Delete Mode and then re-enter it on the required page.Flashes Command Type1 Default Library Command2 Copied Library Command3 Learned CommandOPERATIONUSING THE HTR 7 REMOTE CONTROL32ENGLISH FRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ