Remote control 14-1114.6.2 SETTINGCommandsBehaviourASBK This command aborts a sweep currently in progress previously started by commandSSDO or SSFD. The reply is either:• SBK=OK which means the sweep has been stopped and all settingcommands are available again. In case the sweep was triggered by SSDO,with partial data, data are available for uploading by the command “?FSF 0”• SBK=SERR which informs that the sweep was not in need to be stoppedASPA This command suspends a sweep currently in progress previously started bycommand SSDO or SSFD. There is no reply unless a sweep is not in progress inwhich case the reply is:• SPA=SERR which informs that the sweep was not in need to be pausedASRE This command resumes a sweep previously paused by command ASPA. There is noreply unless a sweep is not in progress in which case the reply is:• SRE=SERR which informs that the sweep was not in need to be resumedS3PRC This setting command #S3PRC* sets the PMM 9010/03P/30P/60P to conductedmode (BANDs A & B). The reply is:• 3PR=OK (The PMM 9010/03P/30P/60P has been set for conducted mode )• 3PR =BERR (The command has been ignored for one of the following:• The connected apparatus is not a PMM 9010/03P/30P/60P• The instrument is not idling and therefore cannot switch to a differentmode. In such an event, stop the current process (Manual, Analyzer orSweep) and put it back to Idle.• 3PR =SERR (The command contains a syntax error )S3PRR This setting command #S3PRR* sets the PMM 9010/03P/30P/60P to radiated mode(BANDS C for 9010/03P and BANDS C, D & E for 9010/30P). The reply is:• 3PR=OK (The PMM 9010/03P/30P/60P has been set for radiated mode )• 3PR =BERR (The command has been ignored for one of the following:• The connected apparatus is not a PMM 9010/03P/30P/60P• The instrument is not idling and therefore cannot switch to a differentmode. In such an event, stop the current process (Manual, Analyzer orSweep) and put it back to Idle.• 3PR =SERR (The command contains a syntax error )SAAT a This setting command sets Attenuator, for Analyzer Mode, to the value indicated by(a) which can be 0 to 35 (55). Automatic Attenuator feature is disabled. If (a) is anegative figure then the Automatic Attenuator feature is turned on. The reply isAAT=OK which acknowledges the command has been granted or AAT=SERR if thecommand has been ignored.Example: # AAT 15* (set attenuator to 15dB and disable Automatic Attenuatorfeature)Example: # AAT -1* (Enable Automatic Attenuator feature)SADT b This setting command sets the detector for Analyzer Mode. The argument (b) shouldbe an index representing the detector as follows:o 1 Peako 2 Avgo 3 RmsThe reply is SADT =OK which acknowledges the command has been granted orSADT =SERR if the command has been ignored.Example: # SADT 1* sets the detector to Peak for Analyzer Mode
