NEC 42/50PD1 User Manual
                                                                | |
Contents
| 
101. Determine the installation location* To ensure safe use, see “Before Use” and “Observethe Following,” then install properly.2. Connect the equipmentSet the termination switch (75Ω/high impedance).Set the DIP switches to suit the application and systemstructure. (See Page 17.)(Loop-out connections are for one unit, maximum.)3. Install the remote control batteries.* To use the remote control in the wired arrangement,connect the supplied remote control cable.4. Connect the supplied power cable* The maximum current rating 5.6(A) : 42PD1* The maximum current rating 0.0(A) : 50PD15. Switch on the power of each of thedevices* When connected with a computer, switch on thepower of the computer first.6. Input an analog RGB signal or a videosignal to this unit7. Select the input mode* Select the appropriate RGB input or video input.8. Adjust the screen* Make adjustments when adjustment of the screendisplay position or distortion is required.9. Adjust the image* Make adjustments when adjustment of the tint,brightness, or contrast is required.Setup ProcedureWarningFor proper installation and mounting it is strongly recom-mended to use a trained, authorized NEC dealer.Failure to follow correct mounting procedures could re-sult in damage to the unit or injury to the installer.Product warranty does not cover damage caused by im-proper installation.Notice:This monitor requires the use of a tabletop stand or wallmount unit for permanent installation and use.This monitor cannot be used without one of these accesso-ries.Note:RETRACTABLE FEET ARE FOR TEMPORARY USEONLY AND ARE NOT INTENDED FOR PERMA-NENT INSTALLATION.MODEL # PX-42VPU1-ST STAND IS REQUIREDFOR PERMANENT TABLETOP INSTALLATION.REPLACE THE FEET WHEN YOU MOVE THEMONITOR. |
Related manuals for NEC 42/50PD1
manualsdatabase
Your AI-powered manual search engine