30* To reset the adjustment value, press the RASTERNORMAL button before pressing the EXIT button.* To delete the main menu, press the EXIT button oncemore.* H-POSITION 1,2 and V-POSITION 1,2 are notavailable at the time of RGB input when AUTO PIC-TURE is turned on.To adjust H-POSITION 1,2 and V-POSITION 1,2 atthe time of RGB input, turn off AUTO PICTURE.* Horizontal and Vertical Position ControlsBoth the horizontal and vertical position controls inthe OSM include a POSITION 1 and a POSITION 2adjustment when an RGB signal is selected fordisplay. These two position controls provide accessto the entire raster position (POSITION 1) and a fineadjustment within the raster (POSITION 2). Firstadjust the POSITION 1 control to set the rasterposition. After the raster position is set properly,then select POSITION 2 to move the image asdesired within the POSITION 1 setting.Adjustment of Screen Position (Horizontal)Horizontal (H) Adjustment Screen1. Align the cursor with icon (2)Horizontal (H) adjustment screen2. Align the cursor with the desired itemThe cursor is moved left and right with the POSITIONCONTROLß / © buttons.The cursor is moved up and down with the POSITIONCONTROL s / t buttons.H-WIDTH: Horizontal enlargement ratio adjustment(Displayed only with Multiple Screens)Adjustment is possible only in multi mode.H-POSITION 2 cannot be adjusted at the time ofVIDEO input.H-POSITION 1: Horizontal position 1H-POSITION 2: Horizontal position 2Adjust when the screen position is unsuitable even aftermaking the adjustment with H-POSITION 1.(Adjustment is not required with a standard signal.)H-WIDTH: Horizontal enlargement ratio adjustment(Displayed only with Multiple Screens)Adjustment is possible only in multi mode.H-POSITION 2 cannot be adjusted at the time ofVIDEO input.3. While watching the screen, press the ß / © buttonsand adjustPOSITION / CONTROL4. Return to the main menuEXITH-POSITION 1H-POSITION 2H-WIDTHIcon (2)H-POSITION 1H-POSITION 2H-WIDTHß MOVE LEFT MOVE RIGHT ©