System Board, Connectors, and Error Messages D-7Message Entering SETUP…Cause Starting the Setup Utility program.Message Extended RAM Failed at offset:nnnn.Cause Extended memory is not working or is notproperly configured at offset:nnnn.Message Fixed Disk 0 or Fixed Disk 1 Failure, or FixedDisk Controller Failure.Cause Fixed (hard) disk drive is not working or notconfigured properly.Solution Make sure the drive is correctly identified in theSetup Utility program and is properly attached.Messagennnn Extended RAM Passed.Cause A total ofnnnn RAM in kilobytes tested good.Message Failing Bits:nnnn.Cause The hex numbernnnn is a map of the bits atthe RAM address that failed the memory test.Each 1 (one) in the memory map indicates afailed bit. The failed memory could be inSystem, Extended or Shadow memory.Message Fixed Disk 0…3 IdentifiedCause Autotyping identified specified fixed disk (harddrive).Message Incorrect Drive A Type or Incorrect Drive BType – run SETUP.Cause Type of floppy drive A or B is not correctlyidentified in Setup Utility program.
