NEC Dterm PSIII User Manual

Also see for Dterm PSIII: User guide

Contents

NEC Dterm PSIII User Manual Manual pdf 22 page image

3-8 Using the PSIIIDterm PSIII User Guide - Revision 1Step 2 Enter the first few letters of the last name and then press theScroll T key. The names matching the letters entered will display.If you enter one character, the names that start with that character will bedisplayed. If you enter two characters, names that start with thosecharacters will display, and so on.If the desired name is not displayed, use the Scroll S or Scroll T keysto locate the next name and number. Continue to press the Scroll S orScroll T keys until you locate the desired name.Step 3 After selecting the name, press L1 or L2* to dial the number.Step 4 To make another selection, press END/PWR, and then repeat the stepsabove.To Use Last Number RedialThe Dterm PSIII retains the last 20 numbers you have called.Step 1 To dial a number using this feature, do the following:—While the PSIII is in a standby state, press the Scroll W key. The PSIIIwill display the last number dialed.—If that is the number you wish to dial, press L1or L2*.—If that is not the number you wish to dial, press the Scroll T key toscroll through the last 20 numbers dialed.To Use Speed DialYou can place a call by searching for a Speed Dial Number by enteringthe number or by using the scroll key.To Place a Call Using Speed DialStep 1 While in a standby state, press the Scroll T key. A Speed Dial dialogbox displays (Figure 3-9).NOTEIf you dial the same number several times, only the latest dialed information will bedisplayed.NOTE*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (orlater) must be used.