NEC Dterm PSIII User Manual

Also see for Dterm PSIII: User guide

Contents

NEC Dterm PSIII User Manual Manual pdf 51 page image

Using the PSIII 3-37Dterm PSIII User Guide - Revision 1To Set Call Forwarding - Don’t Answer Access CodeStep 1 Press FNC+3+5+2. A Call Forwarding - Don’t Answer dialog boxdisplays (Figure 3-45).Figure 3-45 Call Forwarding - Don’t Answer dialog boxStep 2 Press the FNC key or 1. For Mode 2* systems, a Call Forwarding - Don’tAnswer Access Code dialog box displays (Figure 3-46).Figure 3-46 Call Forwarding - Don’t Answer Access Code dialog boxStep 3 Type in the access code to establish call forwarding when a call is notanswered.Example: *4=Call Forwarding - Don’t Answer, Set.Step 4 Press the FNC key to enter.Step 5 Press the FNC key to confirm.A setting tone will ring and then the PSIII returns to a standby state aftertwo seconds.To Cancel Call Forwarding - Don’t AnswerStep 6 Press FNC+3+5+2. A Call Forwarding - Don’t Answer dialog boxdisplays (Figure 3-45).Step 7 Press the FNC key or 2. For Mode 2* systems, a Set Call Forwarding -Don’t Answer Access Code dialog box displays (Figure 3-46).Step 8 Type in the access code to cancel Call Forwarding - Don’t Answer.Example: #4=Call Forwarding - Don’t Answer, Cancel.[1]Set[2]ResetCFW D/AAccess No?NOTE*Mode 2 features are only available with NEAX 2000 (Series 1900 software or later)and NEAX 2400 (Series 7300 software or later). Zone Transceiver 5.00 software (orlater) must be used.