4-50 Configuring Your ServerReconstructionThe reconstruction feature is used to change configuration and/or RAID level of existing virtualdisk. The Reconstruction contains the following three features, however, the Internal RAIDController (equivalent to N8103-116) supports "Migration with addition" only.IMPORTANT: You can use WebBIOS for Reconstruction. UniversalRAID Utility does not support Reconstruction.Removed physical driveUnsupported.Migration onlyUnsupported.Migration with additionUse this feature to add HDDs to existing virtual disk. The execution patterns are as shown below (α:Number of HDDs to be added).Before execution After executionRAIDlevelNumber ofHDDsRAIDlevelNumber ofHDDsDescriptionRAID0 x RAID0 x+α Capacity increased: equivalent to α HDDsRAID0 1 RAID1 2 Capacity remains unchanged.RAID0 x RAID5 x+α Capacity increased: equivalent to α-1 HDDsRAID0 x RAID6 x+α(α=2 or more) Capacity increased: equivalent to α-2 HDDsRAID1 2 RAID0 2+α Capacity increased: equivalent to α+1 HDDsRAID1 2 RAID5 2+α Capacity increased: equivalent to α HDDsRAID1 2 RAID6 2+α Capacity increased: equivalent to α-1 HDDsRAID5 x RAID0 x+α Capacity increased: equivalent to α+1 HDDsRAID5 x RAID5 x+α Capacity increased: equivalent to α HDDsRAID5 x RAID6 x+α Capacity increased: equivalent to α-1 HDDsRAID6 x RAID0 x+α Capacity increased: equivalent to α+2 HDDsRAID6 x RAID5 x+α Capacity increased: equivalent to α+1 HDDsRAID6 x RAID6 x+α Capacity increased: equivalent to α HDDs