1-6 Notes on Using Your ServerRackCAUTIONDo not carry or install the server only by a single person.More than one person is required to carry or install the rack. Failure to follow thisinstruction may cause the rack to fall to result in personal injury and/orbreakages of surrounding devices. In particular, a high rack (such as 44U rack)is unstable if it is not fixed by stabilizers. More than one person must alwayscarry or install the rack while they support it.Do not install the server so that the load may be concentrated on a specificpoint.Install stabilizers on the rack so that the total load of the rack and devicesmounted on the rack is not concentrated on a singe point or join more than onerack with each other to distribute the load. Failure to follow this instruction maycause the rack to fall to result in personal injury.Do not install components on the server only by a single person.More than one person is required to install parts including the doors and trays forthe rack. Failure to follow this instruction may cause some parts to fall to bebroken and/or to result in personal injury.Insert hinges completely.When installing the rack door, make sure that hinge pins at top and bottom ofthe door are completely inserted into the rack. Failure to follow this instructionmay cause the door to fall to be broken and/or to result in personal injury.Anchor the equipment rack.The equipment rack must be anchored to an unmovable support to prevent itfrom falling over when one or more servers are extended in front of it on slideassemblies. The anchors must be able to withstand a force of up to 113 kg (250lbs.) You must also consider the weight of any other device installed in the rack.Do not leave more than one device being pulled out from the rack.Pulling out more than one device from the rack may cause the rack to be fallen.Only pull out a single device from the rack at a time.Do not provide the wiring for the server to exceed the rating of the power supply.To prevent burns, fires, and device damages, the power supplied to the powersupply in the rack shall not exceed the rating load of the power branch circuit.Contact your electric constructor or the local power company for therequirements on the wiring and installation of electric facilities.