Configuring Your Server 4-59Default settings and their explanationItem Default Description ChangeBattery Backup PresentNoneDisplays Properties.• When battery is installed: Present• When battery is not installed: None–Set Factory Defaults [No]YesRestores vendor's factory defaults. Prohibited *1Cluster Mode Disabled – ProhibitedRebuild Rate 30 Recommended value: 30 PermittedPatrol Read Rate 30 Recommended value: 30 PermittedBGI Rate 30 Recommended value: 30 PermittedCC Rate 30 Recommended value: 30 PermittedReconstruction Rate 30 Recommended value: 30 PermittedAdapter BIOS [Enabled]Disabled– ProhibitedCoercion Mode [None]128MB-way1GB-way– ProhibitedPDF Interval 300 – ProhibitedAlarm Control [Disabled]EnabledSilenceDisabled: Does not issue an alarm. Prohibited *2Cache Flush Interval 4 – ProhibitedSpinup Drive Count 2 – ProhibitedSpinup Delay 12 – ProhibitedStopOnError [Disabled]Enabled– ProhibitedStop CC On Error [No]YesSpecify the operation at error detection inConsistency Check.No: Recover and resume.Yes: AbortPermittedMaintain PD FailHistory[Disabled]Enabled– ProhibitedSchdule CC Supported Set the scheduled consistency check. Permitted*1 Do not perform "Set Factory Defaults". If performed, the NEC's factory-set value will no longerbe restored.
