NEC Express5800/120Rh-1 User Manual

Also see for Express5800/120Rh-1: Configuration guide Datasheet

Contents

4-96 Configuring Your ServerDisk ArrayWebBIOS manages Disk Array by a number beginning with 0. You can see a number of Disk Arraywhere [DG X] in Physical Drives and Virtual Drives.Universal RAID Utility manages Disk Array by a number beginning with 1. You can see a numberof Disk Array where [Disk Array] in the property of Logical Drive on RAID Viewer or [RAIDController #X Disk Array #Y] in the property of Disk Array on raidcmd command.Physical Drive and Physical DeviceWebBIOS manages Physical Drive by three numbers (Connector number:Enclosure number:Slotnumber). You can view these numbers shown by [x:x:x] in Physical Drives box. Note, however, theConnector number is always shown as "()" because it is not supported with this server. TheEnclosure numbers are represented by a number beginning with 1, and the Slot numbers arerepresented by a number beginning with 0.Universal RAID Utility manages Physical Device by a number beginning with 1 and ID, Enclosurenumber, and Slot number. The numbers of physical devices connected to the controller are sorted inascending order based on ID and assigned number beginning with 1, starting from the smallestnumber. The ID is same value of Connected Port shown in Physical Drives Properties box inWebBIOS. Enclosure number and Slot number are assigned with a number beginning with 1.IMPORTANT: Note that the slot numbers shown in Physical Drivesbox of WebBIOS are represented by a number beginning with 0, butthose in Universal RAID Utility are represented by a number beginningwith 1.Setting of PriorityWebBIOS displays and sets Rebuild Priority and Patrol Read Priority, Consistency Check Priority ofRAID Controller by percentage. But, Universal RAID Utility uses three levels as High/Middle/Lowfor them.The setting value of WebBIOS and the display level of Universal RAID UtilityItem Setting value of WebBIOS Universal RAID Utility level80 to 100 High31 to 79 MiddleRebuild PriorityRebuild Rate (WebBIOS)0 to 30 Low80 to 100 High31 to 79 MiddlePatrol Read PriorityPatrol Read Rate (WebBIOS)0 to 30 Low80 to 100 High31 to 79 MiddleConsistency Check PriorityConsistency Check Rate(WebBIOS) 0 to 30 Low