6-20 Installing Windows Server 2003 x64 EditionsNetwork DriverSpecify the details of network driver.One standard network driver that is mounted will be installed automatically, but the link speed andDuplex mode need to be specified manually.IP addresses is not be able to set when the "Internet Protocol (TCP/IP)" check box OFF.This phenomenon will occur with the certain condition.Check ON the "Internet Protocol (TCP/IP)" check box and IP address will be able to set.When PROSet is not installed1. Open the [Device Manager].2. Double-click [(Network Adapter Name)] in the list.3. Click the [Advanced] and specify the [Link Speed & Duplex] value the same as the valuespecified for HUB.4. Click [OK].5. Restart the system.When PROSet is installed1. Open the [Device Manager].2. Double-click [(Network Adapter Name)] in the list.3. Click the [Link Speed] and specify the [Speed & Duplex] value the same as the valuespecified for HUB.4. Click [OK].5. Restart the system.Also, add or delete any protocols and services if necessary.You can operate the process on the property dialog box for local area network which can beappeared from [Network and Dial-up Connection].NOTE: It is recommend to add [Network Monitor] at [AddingServices]. [Network Monitor] can monitor the frame (or the packet)that the computer installing [Network Monitor] sends or receives. Thistool is valuable when analyzing network trouble. For information onhow to install the tool, see the "Setting for Solving Problems"described later in this chapter.Re-install the Network DriverThe network driver will be installed automatically.
