3-4 Setting Up Your ServerSELECTING SERVER SITETo use the server, install it on a standard EIA 19-inch rack assembly.Refer to the documentation attached to the rack or contact your service representative for theinstallation of the server on the rack.WARNINGObserve the following instructions to use the server safely. Failure to follow theseinstructions may result in death or serious personal injury. See pages 1-4 to 1-12for details. Do not use the server in any unapproved place. Do not connect the ground line to a gas pipe.CAUTIONObserve the following instructions to use the server safely. Failure to follow theseinstructions may cause a fire, personal injury, or property damage. See pages 1-4 to 1-12 for details. Do not carry or install the server only by a single person. Do not install the server where the load may be concentrated on a specificpoint. Do not install any component on the server only by a single person. Insert the hinge pins completely. Do not pull out a device from the rack if the rack is unstable. Do not leave more than one device being pulled out from the rack. Do not provide the wiring exceeding the rating power. Do not use the server in a place where corrosive gases exist.
