3-14 Setting Up Your ServerCONNECTING PERIPHERAL DEVICESConnect peripheral devices to the server. The server is provided with connectors for wide variety ofperipheral devices. The figure on the next page illustrates available peripheral devices for the serverin the standard configuration and locations of the connectors for the devices.IMPORTANT: Consult with your service representative if you want:– to connect the server to UPS or automatic power control unit– to run the server by scheduled timer– to connect the server to server switch unit and configure itWARNINGObserve the following instructions to use the server safely. Failure to followthese instructions may result in death or serious personal injury. See pages1-4 to 1-12 for details. Do not hold the power plug with a wet hand. Do not connect the ground wire to a gas pipe.CAUTIONObserve the following instructions to use the server safely. Failure to followthese instructions may cause a fire, personal injury, or property damage. Seepages 1-4 to 1-12 for details. Do not plug the power cord in to an improper power source. Do not connect the power cord to an outlet that has an illegal number ofconnections. Insert the power plug into the outlet as far as it goes. Use the authorized power cord only. Do not connect any interface cable with the power cord of the serverplugged to a power source. Do not use any unauthorized interface cable.
