Installing and Using Utilities 5-55Maintenance of the ServerThe server maintenance can be done in two ways; one is to use NEC ESMPRO Manager for remotemaintenance and the other is to use the NEC ESMPRO Agent Server Maintenance Utility on theserver for local maintenance.TIPS:To start the NEC ESMPRO Agent Server Maintenance Utility installed in server, select the itemsas follows:Start Menuo[All Programs]o[NEC ESMPRO Agent]o[Server Maintenance Utility]The maintenance functions that can be executed from NEC ESMPRO include three types, thosecommon to all components, those specific to particular components, and general system settings.The maintenance functions common to all components are operated in the same way basically (theoperation procedure and typical examples of screen images are described below).The table below lists the maintenance functions common to all components.Start Stop MTBFclearDiag-nosisF/WupdateComponentR L R L R L R L R LCPU module – – IO module – –PCI slot – – – – – – – – – –Ethernet board – – – – – – – – – –SCSI adapter – – – – – – – – – –SCSI enclosure – – – – – – – – – –SCSI electronics – – – – – – – – – –SCSI slot – – – – – – – – – –R: Remote. Executable from remote management PC by using NEC ESMPRO ManagerL: Local. Executable on local server by using Server Maintenance Utility: Support–: Not supportThe maintenance operations in the table cannot be performed while collecting dump or updatingfirmware. Wait until such processing is finished to perform the operations in the table.