System Upgrade 8-37Setup of Optional PCI BoardIMPORTANT: To enable the fault-tolerant feature of the optional device, the identical PCI boards must beinstalled to the slots with the same number in CPU/IO module#0 and CPU/IO module#1. The BIOS settings need to be modified when mounting some optional PCI boards. To changethe BIOS settings, start the BIOS setup utility to change the [Boot Monitoring] configurationin [Server] – [Monitoring Configuration]. See page 4-25 for more details. For the supported connecting devices, contact your sales agent.N8804-002 1000BASE-T 1ch board setN8804-003 1000BASE-SX 1ch board setN8804-004 1000BASE-T 2ch board setIMPORTANT:For LAN cable’s connector, use a RJ-45 connector which is compliant with IEC8877 standard. Ifany other connector is used, it may not be removed easily. List of slots to install optional PCI boardsRefer to “List of option PCI boards and installable slots:” on page 8-33. Driver installation procedureTIPS:To perform this procedure, you have to log on the system as an Administrator or a member ofthe Administrators group.For NEC Express5800/ft series, use two option PCI boards in a pair to make dual configuration.After installing OS, install drivers in the following procedure and make dual configuration of thePCI boards.Follow the steps below to install the driver and establish a dual configuration:1. Mount the N8804-002, N8804-003 to the slots with the same number in CPU/IO module#0 and #1, and then start Windows Server 2003.After the OS is started, drivers are installed automatically.IMPORTANT:If the [Digital Signature Not Found] dialog box appears, click the [Yes] button.
