2-24 General Descriptionft Remote Management Card(1) Edge connecting to a serverThis edge of the card connects to the connector for this card in this device.IMPORTANT:Attaching this card to a slot or device other than those specified may cause problems. Donot attach this card to any non-specified slot or device.(2) Management LAN portThis port supporting 100Mbps/10Mbps is used to connect to a network. You cannot use thisport to connect to a telephone line directly. This port is also used for management by NECDianaScope, the management software shipped with the server. LINK/ACT LEDThis LED indicates the network port status. When power is supplied to this card and aconnected device such as a hub and they are connected properly, the LED illuminates ingreen (LINK). When the network port is sending/receiving data successfully the LEDblinks in green (ACT). Speed LEDThis LED indicates the network interface on which network port’s communicationmode is running. When the LED illuminates in amber, it indicates the network interfaceis working on 100Mbps. If the LED does not illuminate, it indicates the networkinterface is working on 10Mbps.IMPORTANT:The speed and duplex settings of the management LAN port are fixed to the autonegotiation mode, and the settings cannot be changed manually.Set the link partner side (switch and hub) to the auto negotiation mode, too.(3) MAC addressThe label containing MAC address information is attached on the other side of this card. Youcan also check the MAC address on the BIOS setup screen on the server.ᴾ
