1095. Using On-Screen Menu[VIDEO LEVEL]This function selects video signal level when the projector’s HDMI and DisplayPort input connectors and an externaldevice are connected.AUTO ��������������������� The video level is switched automatically based on the information from the device outputting the signal�Depending on the connected device, this setting may not be made properly� In this case, switch to “NORMAL”or “ENHANCED” from the menu and view with the optimum setting�NORMAL���������������� This disables the enhanced mode�ENHANCED ������������ This improves the image’s contrast, expressing the dark and light sections more dynamically�Using the Lens Memory Function [LENS MEMORY]This function serves to store the adjusted values for each input signal when using the LENS SHIFT, ZOOM and FO-CUS buttons of the projector or the remote control. Adjusted values can be applied to the signal you selected. Thiswill eliminate the need to adjust lens shift, focus, and zoom at the time of source selection.STORE ������������������� Stores the current adjusted values in memory for each input signal�MOVE �������������������� Applies the adjusted values to the current signal�RESET�������������������� Returns the adjusted values to the last condition�NOTE:• To store adjusted values common to all the input sources, use the REF. LENS MEMORY function. See page 45, 118.• Lens memory adjustments will be automatically registered the ENTRY LIST. These lens memory adjustments can be loaded fromthe ENTRY LIST. (→ page 99)Note that performing [CUT] or [ALL DELETE] in the ENTRY LIST will delete lens memory adjustments as well as source adjust-ments. This deletion will not take effect until other adjustments is loaded.
