Installing the Fuser Components 17GETTING STARTEDI NSTALLING THE F USERC OMPONENTSFollow the steps below to install the Fuser Oil bottle and theFuser Cleaning Roller:1. Open the Top Cover of the printer (A).2. Make sure the Lock Tabs are in the open position (B).3. Remove the orange Tension Release Pins from the endsof the Fuser Rollers. Open the Pressure Release Tabs andpull the pins up and out (C).note: You may have to pull hard to remove these.4. Remove the Fuser Oil Bottle from its plastic bag and setinto place with the shunt valve down and the labeledside facing the front of the printer (D). The tab on thebottle should face right when viewed from the printer’sfront. Place in front of the Lock Tabs.5. Remove the Fuser Cleaning Roller from its plastic bagand set into place with the exposed part of the rollerfacing the front of the printer (E). The extra tab should beon the left. Place in back of the Lock Tabs over the FuserRollers.6. Turn the Lock Tabs to the closed position holding theFuser Oil Bottle and Fuser Cleaning Roller in place (F).7. Close the Top Cover of the printer.A B C DE FLockTabs Open Tension Release PinsGLockTabs ClosedSave the Tension Release Pinsand along with all packingmaterials!
