Scanner Copy Feature 83ADVANCED FEATURESS CANNER C OPY F EATUREThe printer works with the HP ScanJet® 6300C and Astra®1200S, 1220S, or 2400S scanner.Setting Up the ScannerBefore you can print, you must set up the printer to workwith the scanner. If you have an HP 6300 you will need tohave the proper SCSI cable*.1. Make sure the scanner is not plugged into the power andthe printer is turned OFF.2. Plug the SCSI cable from the scanner to the SCSI port onthe Interface Panel of the printer (A).note: The SCSI scanner cable can also be plugged intothe Zip drive SCSI port if a Zip drive is already connectedto the printer. Set the Zip drive terminator to OFF whenattaching the scanner (B).3. Attach the SCSI terminator provided with the scanner tothe SCSI port of the scanner. Refer to the scanner’sdocumentation on how to attach the terminator.4. If you have an Astra scanner, locate the SCSI ID switchon the back of the scanner.If you have an HP scanner go to Step 6. The SCSI IDswitch will set automatically.5. With a small screw driver gently turn the SCSI ID switchto 4, the usual factory default is 5 (C).6. Turn the scanner, Zip drive if present, and then printerON.Caution! Do not plug in the scanner while the printeris turned ON.*SCSI-2 cable with a HD 50-pin male connector and a DB 25-pin male connector.A BC
