B-30 NEO Hand-Held with Windows Mobile 6.1 Classic User ManualAppendix B: Teklogix Imagers AppletMSI PlesseyCheck CharWhen this parameter is enabled, before data is output, the “Codabar” symbol integrity is ver-ified based on a parity character that must be present in the code. If the parity character is notpart of the code, the code is not output. Keep in mind the parity character may not be part ofyour output setup; in this case, this parameter should be turned off.Check Char StripIf you enable this parameter, a check character is stripped from the decoded bar code data.Concatenation“Codabar” supports symbol concatenation. When Concatenation is set to on, Codabar uses a‘D’ stop character to indicate that data from that symbol should be concatenated with datafrom the adjacent symbol with a ‘D’ start character.Minimum and Maximum LengthThe length of a code refers to the number of characters (i.e., human readable characters), in-cluding check digit(s). Double-tapping on these parameters displays a screen in which youcan set the minimum and maximum allowable code lengths – 2 to 60.B.5.12 MSI PlesseyEnabledSet this parameter to on to enable MSI.Enable PlesseySet this parameter to on to enable Plessey.Check CharWhen this parameter is set to on, the integrity of a “MSI Plessey” symbol is checked toensure that it complies with specified algorithms.Minimum and Maximum LengthThe length of a code refers to the number of characters (i.e., human readable characters), in-cluding check digit(s). Double-tapping on these parameters displays a screen in which youcan set the minimum and maximum allowable code lengths – 4 to 48.Plessey Minimum and Plessey Maximum LengthThese parameters apply to Plessey bar codes.The length of a code refers to the number ofcharacters (i.e., human readable characters), including check digit(s). Double-tapping on
