Using the Built-in FlashThe camera supports a variety of flash modes for photographing poorly lit or backlitsubjects.Note that the built-in flash cannot be used, nor can the flash mode be changed, in ~, @,or Ili mode.Using the Built-in Flash: A~, :I, -5, ~, and 1£1 Modes1 Rotate the mode dial to A~, :i, -5, ~, or 1:lI.2 Confirm or change the current flash mode (tyj 65).Select @ to prevent the flash from firing.The flash will fire whenever a photograph is taken. Toprevent the flash from firing, lower the flash .Press ~ to raise the flash.Using the Built-in Flash: P, S, A, and M Modes1 Rotate the mode dial to P, S, A, or M.23 Frame a photograph and shoot.The flash will pop up as required when the subject ispoorly lit or backlit.The flash mode can be changed after the flash popsup.Press the shutter-release button all the way down toshoot.:::JlOVI(1)a.:::JlOVIn::TQJ:::JlO<6 4 Lower the flash when it is no longer needed.VI::Too....•..3 Confirm or change the current flash mode (tyj 65).........................•... . ..........................................•......................4 Choose a metering method (t;l62), adjust exposure, frame the photograph,and shoot.Lowering the Built-in FlashTo save power when the flash is not in use, press it gentlydownward until the latch clicks into place.64
