WLAN AP ROUTER 802.11N123Push Button methodWireless Gateway supports a virtual button “Start PBC” on theWi-Fi Protected Setup page for Push Button method. If userspush a virtual button “Start PBC”, AP will initiate a WPS sessionand wait for any station to join. At this moment, AP will detectwhether there is more than one station that starts the PBCmethod. When multiple PBC sessions occur, users should tryPIN method.After users push AP’s virtual button “Start PBC”, they must go tostation side to push its button within two minutes. If the WPS issuccessfully done, AP will give its wireless profile to that station.The station could use this profile to associate with AP.1. From the left-hand Wireless -> WPS menu. The followingpage is displayed:2. Make sure AP is in un-configured state.3. Click Start PBC.
