Nortek 2GIG GC3 User Manual
Also see for 2GIG GC3: Installation and programming guideUser guideInstallation and programming guideUser guide
                                                                                      | |
Contents
| 
Copyright © 2019 Nortek Security & Control LLC. 25This changes the system’s status back to System NotReady to Arm and moves the sensor to the Sensors NotReady list.System Not Ready to Arm—Sensors Not Ready ListUse the Quick Exit ButtonThe Quick Exit button gives users the ability to start anExit Delay countdown while the system is armed. Thisgives users the ability to leave the premises through anExit/Entry door, instead of having to disarm and then rearmthe system. When the Allow Quick Exit setting is enabled,the Quick Exit button appears on the System Armed(STAY) screen.NOTE: Consult your installer to determine if theAllow Quick Exit setting is enabled or disabled onthe system.To use the Quick Exit button:1. Arm the system in Stay Moder. See “Arm theSystem.”2. At the System Armed (STAY) screen, tap QuickExit.System Armed—Quick Exit ButtonThis starts the Exit Delay countdown to give you time toexit through an Exit/Entry door without having to re-arm thesystem. At the end of the countdown, the system arms itselfin the appropriate mode.In the Event of an Exit ErrorIf you arm the system and an Exit/Entry door is left ina violated state or condition at the time the Exit Delaycountdown expires (for example, the door you exit fromdoesn’t close behind you), the GC3e Panel sounds thelocal alarm and the Entry Delay countdown begins. Ifyou do not disarm the system when the Entry Delaycountdown begins, the system automatically begins thealarm transmission sequence. The panel also transmits anExit Error report to the Central Station and displays an ExitError message on the panel screen, as shown below.Alarm Transmission & Exit Error SequenceTo Disarm the SystemTo turn the system’s burglary protection sensors OFF, youdisarm the system. Disarming the system also silences anytype of alarm that might be sounding.NOTE: To use this feature, you must have an active,four-digit user code. See your system’s Master Userto obtain a code.Disarm the System (Stay Mode)When the system is armed in Stay Mode, any person withan active, four- digit user code can disarm the system.To disarm the system:1. At the System Armed screen, tap Disarm.System Armed > Disarm Button |
Related manuals for Nortek 2GIG GC3
manualsdatabase
Your AI-powered manual search engine