Configuring AP access points 259Nortel WLAN Security Switch 2300 Series Configuration GuideFor the serial-id parameter, specify the serial ID of the AP. The serial ID is listed on the AP case. To displaythe serial ID using the CLI, use the show version details command.The model and radiotype parameters have the same options as they do with the set port type ap command.Because the WSS switch does not supply power to an indirectly connected AP, the set dap command does notuse the poe parameter.To configure Distributed AP connection 1 for AP model 2330 with serial-ID 0322199999, type the followingcommand:23x0# set dap 1 serial-id 0322199999 model 2330success: change accepted.(To specify the external antenna type, use the set {ap | dap} radio antennatype command. See “Configuringthe External Antenna Model” on page 274.)To configure Distributed AP connection 2 for AP model AP-241 with serial-ID 0322188888 and radio type802.11a, type the following command:23x0# set dap 2 serial-id 0322188888 model AP-241 radiotype 11asuccess: change accepted.Clearing an AP from the ConfigurationTo clear the port settings from a port, use the following command:clear port type port-listThis command resets the port as a network port and removes all AP-related parameters from the port.To clear a Distributed AP, use the following command:clear dap dap-numChanging AP NamesThe default name of a directly attached AP is based on the port number of the AP access point attached to theAP. For example, the default name for an AP on AP access point 1 is AP01. The default name of a DistributedAP is based on the number you assign to it when you configure the connection. For example, the default namefor Distributed AP 1 is DAP01.Warning! When you clear an AP access port, WSS Software ends user sessions thatare using the AP.Note. The clear port type command does not place the cleared port in any VLAN, noteven in the default VLAN (VLAN 1). To use the cleared port in a VLAN, you must add theport to the VLAN. (For instructions, see “Adding Ports to a VLAN” on page 92.)
