572 Appendix A: Troubleshooting a WS Switch320657-AFixing Common WSS Setup ProblemsTable 36 contains remedies for some common problems that can occur during basic installation and setup of an WSSswitch.Table 36: WSS Setup Problems and RemediesSymptom Diagnosis RemedyWLAN ManagementSoftware or a webbrowser (if you are usingWeb View) warns that theWSS switch’s certificatedate is invalid.The switch’s time and date arecurrently incorrect, or wereincorrect when you generatedthe self-signed certificate orcertificate request.1. Use set timezone to set the time zone inwhich you are operating the switch. (See“Setting the Time Zone” on page 137.)2. Use set timedate to configure the currenttime and date in that time zone. (See“Statically Configuring the System Timeand Date” on page 139.)3. Reconfigure the administrativecertificate(s). (See Chapter , “ManagingKeys and Certificates,” on page 379.)4. If you have already configured a certificateon the switch for authentication by networkusers, you must recreate this certificate, too.WSS switch does notaccept configurationinformation for an APaccess point or a radio.The country code might not beset or might be set for anothercountry.1. Type the show system command to displaythe country code configured on the switch.2. If the value in the System Countrycode fieldis NONE or is for a country other than theone in which you are operating the switch,use the set system countrycode commandto configure the correct country code. (See“Specifying the Country of Operation” onpage 248.)
