Configuring AAA for Administrative and Local Access 65Nortel WLAN Security Switch 2300 Series Configuration GuideDisplaying the AAA ConfigurationTo display your AAA configuration, type the following command:23x0# show aaaDefault Valuesauthport=1812 acctport=1813 timeout=5 acct-timeout=5retrans=3 deadtime=0 key=(null) author-pass=(null)Radius ServersServer Addr Ports T/o Tries Dead State-------------------------------------------------------------------r1 192.168.253.1 1812 1813 5 3 0 UPServer groupssg1: r1set authentication console * localset authentication admin * localset accounting admin Geetha stop-only localset accounting admin * start-stop localuser GeethaPassword = 1214253d1d19 (encrypted)(For information about the fields in the output, see the Nortel WLAN Security Switch 2300 Software CommandReference.)Saving the ConfigurationYou must save the configuration for all commands that you enter and want to use for future sessions. After you enter theadministrator’s AAA configuration, type the following command to maintain these commands in WSS nonvolatilememory:23x0# save configsuccess: configuration saved.You can also specify a filename for the configuration—for example, configday. To do this, type the following command:23x0# save config configdayConfiguration saved to configday.You must type the save config command to save all configuration changes since the last time you rebooted the WSSswitch or saved the configuration. If the WSS switch is rebooted before you have saved the configuration, all changesare lost.You can also type the load config command, which reloads the WSS switch to the last saved configuration or loads aparticular configuration filename. (For more information, see “Managing Configuration Files” on page 526.)
