Rogue Detection and Countermeasures 561Nortel WLAN Security Switch 2300 Series Configuration GuideDisplaying RF Detection InformationYou can use the CLI commands listed in Table 35 to display rogue detection information.Table 35: Rogue Detection Show CommandsCommand Descriptionshow rfdetect clients[mac mac-addr]Displays all wireless clients detected on the air.show rfdetect counters Displays statistics for rogue and IntrusionDetection System (IDS) activity detected by theAPs managed by an WSS switch.show rfdetect mobility-domain[ssid ssid-name | bssid mac-addr]Displays information about rogues detected in aMobility Domain.This command is valid only on the MobilityDomain’s seed switch.show rfdetect data Displays information about all BSSIDs detectedon the air, and labels those that are from roguesor interfering devices.This command is valid on any switch in theMobility Domain.show rfdetect visible mac-addrshow rfdetect visibleap AP-num [radio {1 | 2}]show rfdetect visibledap dap-num [radio {1 | 2}]Displays the BSSIDs detected by a specificNortel radio.show rfdetect countermeasures Displays the current status of countermeasuresagainst rogues in the Mobility Domain.This command is valid only on the MobilityDomain seed.show rfdetect vendor-list Displays the list of OUIs that are allowed on thenetwork. An OUI identifies a piece ofnetworking equipment’s vendor. (See“Configuring a Permitted Vendor List” onpage 544.)show rfdetect ssid-list Displays the list of SSIDs that are allowed onthe network. (See “Configuring a PermittedSSID List” on page 545.)show rfdetect black-list Displays the list of wireless clients that are bothallowed on the network. (See “Configuring aClient Black List” on page 546.)
