298 Configuring RF Auto-Tuning320657-AChanging Power Tuning SettingsEnabling Power TuningRF Auto-Tuning for power is disabled by default. To enable or disable the feature for all radios in a radioprofile, use the following command:set radio-profile name auto-tune power-config {enable | disable}To enable power tuning for radios in the rp2 radio profile, type the following command:23x0# set radio-profile rp2 auto-tune power-config enablesuccess: change accepted.Changing the Power Tuning IntervalThe default power tuning interval is 300 seconds. You can change the interval to a value from 1 to 65535seconds. To change the power tuning interval, use the following command:set radio-profile name auto-tune power-interval secondsTo set the power tuning interval for radios in radio profile rp2 to 240 seconds, type the following command:23x0# set radio-profile rp2 auto-tune power-interval 240success: change accepted.Changing the Power Backoff IntervalThe default power backoff interval is 10 seconds. You can change the interval to a value from 0 to 65535seconds. To change the power backoff interval, use the following command:set radio-profile name auto-tune power-backoff-timer secondsTo change the power-backoff interval for radios in radio profile rp2 to 15 seconds, type the followingcommand:23x0# set radio-profile rp2 auto-tune power-backoff-timer 15success: change accepted.Changing the Maximum Default Power Allowed On a RadioBy default, the maximum default power level that RF Auto-Tuning can set on a radio is the same as themaximum power level allowed for the country of operation. To change the maximum default power level thatRF Auto-Tuning can assign, use the following command:set {ap port-list | dap dap-num} radio {1 | 2} auto-tune max-power power-levelThe power-level can be a value from 1 to 20.
