Managing System Files 527Nortel WLAN Security Switch 2300 Series Configuration GuideDisplaying the Running ConfigurationTo display the configuration running on the WSS switch, use the following command:show config [area area] [all]The area area parameter limits the display to a specific configuration area. (For more information, see the NortelMobility System Software Command Reference.)The all parameter includes all commands that are set at their default values. Without the all parameter, the show configcommand lists only those configuration commands that set a parameter to a value other than the default.To display the running configuration, type the following command:23x0# show config# Configuration nvgen'd at 2004-5-10 19:08:38# Image 2.1.0# Model WSS-20# Last change occurred at 2004-5-10 16:31:14set trace authentication level 10set ip dns server 10.10.10.69 PRIMARYset ip dns server 10.20.10.69 SECONDARYset ip route default 10.8.1.1 1set log console disable severity debugset log session disable severity alertset log buffer enable severity error messages 200set log trace disable severity error mbytes 10set log server 192.168.253.11 severity criticalset timezone PST -8 0set summertime PDT start first sun apr 2 0 end last sun oct 2 0set system name WSS-20set system countrycode USset system contact nortel-pubsset radius server r1 address 192.168.253.1 key sunflowerset server group sg1 members r1set enablepass password b6b706525e1814394621eeb2a1c4d5803fcfset authentication console * noneset authentication admin * noneset user tech password encrypted 1315021018press any key to continue, q to quit.To display only the VLAN configuration commands, type the following command:23x0# show config area vlan# Configuration nvgen'd at 2004-5-10 19:08:38# Image 2.1.0# Model WSS-20# Last change occurred at 2004-5-10 16:31:14set vlan 1 port 1set vlan 10 name backbone tunnel-affinity 5set vlan 10 port 21
