112 Chapter 2 Using the console interface320985-A Rev 01High Speed Flow Control Configuration screenThe High Speed Flow Control Configuration screen (Figure 24) allows you toset the port parameters for the Gigabit Ethernet Interface.➨ Choose High Speed Flow Control Configuration (or press h) from theSwitch Configuration Menu screen.Status Allows you to disable any of the switch ports. You can also use this field to controlaccess to any switch port.Default Value EnabledRange Enabled, DisabledLink A read-only field that indicates the current link state of the corresponding port, asfollows:• Up: The port is connected and operational.• Down: The port is not connected or is not operational.LnkTrap Allows you to control whether link up/link down traps are sent to the configured trapsink from the switch.Default Value OnRange On, OffAutonegotiation When enabled, sets the corresponding port speed to match the best service providedby the connected station, up to 100 Mb/s in full-duplex mode. This field is disabled forall fiber optic ports.Default Value EnabledRange Enabled, DisabledSpeed/Duplex Allows you to manually configure any port to support an Ethernet speed of 10 Mb/sor 100 Mb/s, in half- or full-duplex mode. This field is set (by default) to 1000 Mb/s,full-duplex for Gigabit ports only.Default Value 10Mbs/Half (when Autonegotiation is Disabled)Range 10Mbs/Half, 10Mbs/Full, 100Mbs/Half, 100Mbs/FullNote: The GBIC module must be installed to configure the port.Table 17 Port Configuration screen fields (continued)Field Description