258 Chapter 7 System configuration using the CLI320985-A Rev 01no ip address unit commandThe no ip address unit command sets the IP address for the specified unit ina stack to all zeros (0). The syntax for the no ip address unit command is:no ip address unit <1-8>The no ip address unit command is in the config command mode.Table 64 describes the parameters and variables for the no ip address unitcommand.default ip address unit commandThe default ip address unit command sets the IP address for thespecified unit in a stack to all zeros (0). The syntax for the default ipaddress unit command is:default ip address unit <1-8>The default ip address unit command is in the config command mode.Note: When you change the IP address or subnet mask, you may loseconnection to Telnet and the Web.Table 64 no ip address unit command parameters and variablesParameters andvariables Descriptionunit <1-8> Zeroes out the IP address for the specified unit.Note: When you change the IP address or subnet mask, you may loseconnection to Telnet and the Web.You also disable any new Telnetconnection, and you must connect to the serial console port to configurea new IP address.
