144 Chapter 3 CLI Basics320985-A Rev 01show mac-address-table commandThe show mac-address-table command displays the current contents of theMAC address forwarding database table. The syntax for the showmac-address-table command is:show mac-address-table [vid <1-4094> ] [aging-time][address ] [port ] [include/exclude <pattern>]The show mac-address-table command is in the privExec command mode.Table 26 describes the parameters and variables for the showmac-address-table command.Table 26 show mac-address-table command parameters and variablesParameters andvariables Descriptionvid <1-4094> Enter the number of the VLAN you want to display theforwarding database.Default is to display the management VLAN’s database.aging-time Displays the time in seconds after which an unused entry isremoved from the forwarding database.address Displays a specific MAC address if it exists in the database.Enter the MAC address you want displayed.port List of ports.include/exclude<pattern>Allows you to filter the results of the command by printingonly those entries in the address table that include or excludea given pattern. The value for <pattern> must be a sequenceof 1 to 6 bytes in hex, separated by dashes.for example: show mac-address-tableport 1/1-5 address include 00-0E-45-23
