72 Chapter 1 About Ethernet Switches 325 and 425320985-A Rev 01Aborting a commandTo abort a command entered using the UI button, do one of the following actions:• Wait for about 20 seconds after entering either the one-press (set to base unit)or the two-press (reset to base) and the input is ignored.• Press the UI button 7 or more times, which exits the Configuration mode anddoes not change any settings on the switch.Setting the default IP addressYou can set a default IP address and subnet mask for the switch or stack by usingthe UI button on the front panel of the Ethernet Switch 425. You can also managethe switch or stack remotely by using a Default IP address. The default IP addressis 192.168.192.168.Depending on the mode of operation of the switch (standalone or stack) thedefault IP address is applied to the local unit or to the entire stack. When theEthernet Switch 425-24T is operating in the stack mode, the UI button on the frontpanel on any unit of the stack can be used to set the default IP address. Ensure thatyou do not create duplicate IP addresses on the network.Down Green/steady The unit is being set as base or non-base unitusing the UI button — base unit has BaseLED on as well.Amber/blinking The stack is reset using the UI button.Note: The UI button may be used at any time to change the In-Use IPaddress and subnet mask of the switch. It overrides the current In-use IPaddress and subnet mask, if any, regardless of the BootP mode settingsfor the switch or stack.Label Color/Status Description
