11Installation and Maintenance Guide10 To reduce the risk of electric shock do not disassemble this product, but have it sent to aqualified service person when some service or repair work is required.11 Unplug this product from the wall outlet and refer servicing to qualified service personnelunder the following conditions:a When the power supply cord or plug is damaged or frayed.b If the product has been exposed to rain, water or liquid has been spilled on the product,disconnect and allow the product to dry out to see if it still operates; but do not open up theproduct.c If the product housing has been damaged.d If the product exhibits a distinct change in performance.12 Avoid using a telephone during an electrical storm. There may be a remote risk of electricshock from lightning.13 Do not use the telephone to report a gas leak in the vicinity of the leak.14 Caution: To eliminate the possibility of accidental damage to cords, plugs, jacks, and thetelephone, do not use sharp instruments during the assembly procedures.15 Warning: Do not insert the plug at the free end of the handset cord directly into a wall orbaseboard jack. Such misuse can result in unsafe sound levels or possible damage to thehandset.16 Save these instructions.International Regulatory InformationThis is a class A product. In a domestic environment this product may cause radio interference inwhich case the user may be required to take adequate measures.Hereby, Nortel Networks declares that this equipment is in compliance with the essentialrequirements and other relevant provisions of Directive 1999/5/EC.Information is subject to change without notice. Nortel Networks reserves the right to make changes in designor components as progress in engineering and manufacturing may warrant. This equipment has been testedand found to comply with the European Safety requirements EN 60950 and EMC requirements EN 55022(Class A) and EN 55024. These EMC limits are designed to provide reasonable protection against harmfulinterference when the equipment is operated in a commercial and light industrial environment.The CE Marking on this equipment indicatescompliance with the following:This device conforms to Directive 1999/5/EC onRadio Equipment and TelecommunicationsTerminal Equipment as adopted by the EuropeanParliament And Of The Council.
