Chapter 7 Setting media bay module DIP switches 89Installation and Maintenance GuideDetermining module DIP switch settingsAfter you determine in which order you want to assign the modules, you determine the specificswitch settings for each module.1 Use Table 11 on page 90 to determine a switch setting for all modules except FEM modules.Figure 39 shows an example of the table and how to do the following steps:Step 1: On Table 11 circle the module names.Step 2: Number the order in which you want to assign the modules.Step 3: Determine the number of DS30 blocks each module requires.Step 4: Circle the DS30 bus and offset numbers.Step 5: Follow the DS30 bus and offset number to the far right column where the switchsettings are indicated. Circle the setting for each module.Figure 39 How to use the configuration mapNote: If you must assign specific line or extension numbers to a module, refer to theindividual switch tables in “Line and extension numbers for specific modules” on page 93for line and DN listings.DS30bus # OffsetMedia bay module positioning DIP switch settingDSM16DSM 32 4x16 ASM8DTM CTM CTM8 BRI1 2 3(offset)4 5 6(DS30)2 0 on on on on on on7 0 on on on off on off1 on on off off on off2 on off on off on off3 on off off off on off1. Indicate the modules you want to install2. Note how many DS30 bus numbers each module requires3. Choose the DS30 blocks toassign to the modules4. Assign an offset number toeach module5. Make a note of the DIP switch settingsfor the DS30 bus #/offset123455DIP switchsetting foroffset
