106 Chapter 7 Setting media bay module DIP switchesN0008587 01Table 25 DSM 16+ and DSM32+ double density switch settings for 2.5 systems upgraded to BCM 3.0 ornewer softwareSelectDS30bus #Enter these switchsettings2 To assign theseDNs to DSM 16+:(A=DSM1, B=DSM2)To assign these DNsto DSM 32+(connectors:A=top, B=bottom)2 Custom DNrange1 2 3 4 5 602on on on on on A 221-236 A 377-392offon on on on B 377-392 B 221-236off off03on on on on A 237-252 A 393-408off offon on on B 393-408 B 237-252off off off04on on on on A 253-268 A 409-424off offon on on B 409-424 B 253-268off off off05on on on A 269-284 A 425-440off off offon on B 425-440 B 269-284off off off off06on on on on A 285-300 A 441-4563off offon on on B 441-4563 B 285-300off off off071on on on A 301-316 A 457-4724off off offon on B 457-4724 B 301-3164off off off off1 If your system is configured with a 3/5 split, you cannot use DS30 07 for the DSM 16 module.2 The extensions listed are based on a three-digit DN with a Start DN of 221. If your system has longer DNs or adifferent Start DN, enter the range in the blank column.3 Available only on systems set to FDD. Modules cannot be set to double density on systems set to PDD. Refer to theprevious chart for the switch settings for single density and PDD.4 Available only on systems set to FDD, with a 2/6 DS30 split. Modules cannot be set to double density on systemsset to PDD. Refer to the previous chart for the switch settings for single density and PDD.
