204 Chapter 16 Using Element Manager to set the basic parametersN0060612N00606125 Configure the attributes for Modify SNMP Settings (see Table 74).6 Click Ok.To configure SNMP community strings1 From the Configuration tab, click the Administrator Access folder to expand it.2 Select SNMP from the Administrator Access folder.3 Select the Community Strings tab.4 Click Add.... The Add Community String dialog box opens.5 Configure the Add Community String attributes (see Table 75).6 Click Ok.7 Repeat steps 4 to 6 to add more community strings.To configure the SNMP manager listUse the SNMP manager list to specify IP addresses that are allowed to connect to the SNMP agent.1 From the Configuration tab, click the Administrator Access folder to expand it.2 Select SNMP from the Administrator Access folder.3 Select the General tab. It is normally selected by default.4 Click Add... in the SNMP Manager List area. The Add Manager dialog box opens.5 Enter the IP address in the Manager IP Address field.6 Click Ok.7 Repeat steps 4 to 6 to add another manager IP address.Table 74 Modify SNMP Settings attributesAttribute DescriptionEnable SNMP Agent Select whether to enable or disable the SNMP agent by selecting (or notselecting) the check box.Minimum required security Select the minimum required security for SNMP from the drop-down list.SNMP Version Support Select the SMNP version support from the drop-down list.Table 75 Add Community String attributesAttribute DescriptionCommunity string Enter the entry name used as a key to uniquely identify an individualcommunity entry on the SNMP agent.Type of access Specify the read and write access for this community. Available options areRead Only and Read/Write.
