127Using the BayStack Instant Internet Management Software Version 7.11Chapter 5Advanced IP configurationWhen you initially install and configure Instant Internet, it uses a set of defaultservices that most network administrators will prefer to use. If you want InstantInternet to use IP services that are different than the defaults, you need to useSetup to configure the IP services that you want it to use. This chapter providesinformation on configuring IP services for Instant Internet.For more information about these services, refer to Reference for the BayStackInstant Internet Remote Access Commands Version 7.11.Using SetupSetup is the utility you use to create and configure servers and services for theInstant Internet unit. When you install Instant Internet, you create and configuregeneral servers and services. You can change these settings using Setup.To start Setup:1 From the Instant Internet program group or menu (depending on youroperating system), select Setup.2 The next step varies depending on your individual configuration. Select theoption that best fits your configuration:• If you have an IP network or a network with more than one InstantInternet unit, the Instant Internet Units dialog box opens. Select theappropriate unit, and then click OK. If you do not see the Instant Internetunit in the list, refer to “Adding a unit to the selection list” on page 275.• If you have an IPX network with one Instant Internet unit, the InstantInternet Setup main window opens.
